JLG 3246E2 Service Manual - Manual (Page 30)

SECTION 2 - PROCEDURES
2-18 – JLG Sizzor – 3120855
2.15 DRIVE MOTOR (SAUER DANFOSS)
Dismantling
1. Place motor in proper holding device that allows
access to the output shaft.
2. Carefully remove end cover sideways being sure to
catch any parts that may fall from the gearwheel.
3. The needles bearings will fall out during dismantling
and can be collected and reused. The outer ring and
thrust bearing need not be removed.
4. With the housing in the holding device, press the
shaft out of the housing. Collect the needle bearings
for possible re-use.
5. Remove the housing from the holding device and
place on a workbench. With a screwdriver, gently
lever the dust seal ring from the housing.
6. Extract the shaft seal from the housing.
7. Press the remaining parts out using hydraulic equip-
ment.
8. Clean all parts carefully with a low aromatic kero-
sene.
Figure 2-14. Drive Motor (Sauer Danfoss)