JLG 3246E2 Service Manual User Manual
Page 40
SECTION 2 - PROCEDURES
2-28
– JLG Sizzor –
3120855
NOTE: Bearing mandrel must be pressed against the let-
tered end of bearing shell. Take care that the hous-
ing bore is square with the press base and the
bearing/bushing is not cocked when pressing a bear-
ing/bushing into the housing.
IF THE BEARING MANDREL SPECIFIED IN THE “TOOLS AND
MATERIALS REQUIRED FOR SERVICING” SECTION IS NOT
AVAILABLE AND ALTERNATE METHODS ARE USED TO PRESS
IN BEARING/BUSHING (13) AND (19) THE BEARING/BUSHING
DEPTHS SPECIFIED MUST BE ACHIEVED TO INSURE ADEQUATE
BEARING SUPPORT AND CORRECT RELATIONSHIP TO ADJA-
CENT COMPONENTS WHEN ASSEMBLED.
BECAUSE THE BEARING/BUSHINGS (13) AND (19) HAVE A
PRESS FIT INTO THE HOUSING THEY MUST BE DISCARDED
WHEN REMOVED. THEY MUST NOT BE REUSED.
2.
The Torqlink™ inner housing bearing/bushing (13)
can now be pressed into its counterbore in housing
(18) flush to 0.03 inch (.76 mm) below the housing
wear plate contact face. Use the opposite end of the
bearing mandrel that was used to press in the outer
bearing/bushing (19).
3.
Press a new dirt and water seal (20) into the housing
(18) outer bearing counterbore.