JLG 3246E2 Service Manual - Manual (Page 47)

SECTION 2 - PROCEDURES
3120855 – JLG Sizzor – 2-35
the seventh or full complement of seven vanes.
Assemble the seven vanes using minimum force.
Remove the two assembled bolts (1) if used to retain stator
and wear plate.
2.18 LIMIT SWITCH ADJUSTMENT
Platform Limit Switch
The platform limit switch is located at the head of the lift
cylinder on the middle inside arm. When activated, the
switch cuts out the High Drive function. The cut out
heights are set at a maximum of the following:
1932E2 - 2.6 m
2032E2 - 2.1 m
2632E2 - 2.6 m
2646E2 - 2.6 m
3246E2 - 1.6 m
2.19 DOOR ADJUSTMENT
NOTE: There is an eccentric bolt on the hinge side under-
neath of each door. If the door needs raised or low-
ered this can be accomplished by turning these
bolts. Adjust these bolts to the outside to avoid drag
on the pothole protection system when the door is
opened.
NOTE: There are two bolts on top of each door in the cor-
ners. These are designed to take the weight off the
pothole protection system and distribute it around
the underside of the frame if the machine were to be
run over any uneven terrain or dropped into any
void. The clearance between the top of the bolts and
the frame should be a min.of 2.0 cm to a max. of 4.0
cm.
2.20 JLG SMART SYSTEM™ ANALYZER KIT
INSTRUCTIONS
NOTE: The following instructions involving the JLG SMART
System™ Control are used only for Model 3246E2
with the Proportional Control option.
WHEN INSTALLING A NEW SMART SYSTEM CONTROLLER ON
THE MACHINE, IT WILL BE NECESSARY TO PROGRAM THE CON-
TROLLER FOR THE PROPER MACHINE CONFIGURATION,
INCLUDING OPTIONS. REFER TO ANALYZER KIT NO. 2901443.
WHEN INSTALLING A NEW SMART SYSTEM CONTROLLER ON
THE MACHINE, ELECTRICAL SILICONE GREASE, JLG PART
NUMBER 0100076 OR 7016397, MUST BE APPLIED TO THE BACK
OF THE CONTROLLER.
IT IS A GOOD PRACTICE TO AVOID PRESSURE-WASHING ELEC-
TRICAL/ELECTRONIC COMPONENTS. SHOULD PRESSURE-
WASHING BE UTILIZED TO WASH AREAS CONTAINING ELECTRI-
CAL/ELECTRONIC COMPONENTS, JLG INDUSTRIES, INC. REC-
OMMENDS A MAXIMUM PRESSURE OF 52 BAR (750 PSI) AT A
MINIMUM DISTANCE OF 30.5 CM (12 IN) AWAY FROM THESE
COMPONENTS. IF ELECTRICAL/ELECTRONIC COMPONENTS
ARE SPRAYED, SPRAYING MUST NOT BE DIRECT AND BE FOR
BRIEF TIME PERIODS TO AVOID HEAVY SATURATION.
Figure 2-16. JLG SMART System™ Controller