JLG 3246E2 Service Manual - Manual (Page 54)

SECTION 2 - PROCEDURES
2-42 – JLG Sizzor – 3120855
2.23 MACHINE CONFIGURATION
INFORMATION
NOTE: The following information is to be used when working
with the MACHINE SETUP menu. When configuring
the E Series scissor lift, the machine configuration
must be completed before any personality settings
can be changed. Changing the personality settings
first and then changing the model number of the
machine configuration will cause the personality set-
tings to return to default values.
Table 2-6. Machine Configuration Programming Information
Configuration Digit Number Description
Default Setting
Before
Programming
1
(MODEL NUMBER)
1
2
3
4
5
6
7 MODEL 1532E3
MODEL 1932E3
MODEL 2033E3
MODEL 2046E3
MODEL 2646E3
MODEL 2658E3
MODEL 3246E2 3
2
(TILT SWITCH)
0
1
2
No tilt switch installed.
Tilt switch installed for North american, CE, and optional for Latin American
machines. This digit will allow the SMART System™ to indicate when the machine is
out of level by lighting the light in the platform box. If the machine is elevated and tilted,
the SMART System™ will also sound the platform alarm continuously. No functions
are cutback or cutout.
Tilt switch for Australia, Japanese, and option for Latin American machines. This digit
will allow the SMART System™ to indicate when the machine is out of level by lighting
the light in the platform box. If the machine is elevated and tilted, the SMARtT Sys-
tem™ will also sound the platform alarm continuously and the
lift up and drive func-
tions are cutout.l
0
3
(POWER DECK)
0
1
No power deck installed.
Machine equipped with power deck.
0
4
(DECK EXT. LIMIT
SWITCH)
0
1
2
Deck extension limit switch not installed. (This cannot be zero if there is a power deck
installed.)
Cuts out LIFT DOWN when deck is extended. This digit is used with roll out decks that
require a deck extension cutout. Sounds platform alarm for one second on, one sec-
ond off, one second on, and three seconds off while operator tries to perform the func-
tion that has been cut out (provided the platform alarm has been installed).
Cuts out HIGH DRIVE when deck is extended and below elevation. Cuts out DRIVE
when deck is extended and above elevation. This digit is used with a power deck.
Sounds platform alarm for one second on, one second off, one second on, and three
seconds off while operator tries to perform the function that has been cut out and dur-
ing the LIFT DOWN function (provided the platform alarm has been installed).
0