BURY CP 1000 CarPhone USER Manual - Manual (Page 8)

8
Installation of the system
4. Positioning and mounting
Step 1:
First of all, please choose the most convenient position for the BURY CP
1000 CarPhone in your vehicle by checking different positions in the
vehicle.
When installing the BURY CP 1000 CarPhone avoid positioning the sys-
tem where it may disrupt the proper operation of the vehicle and its
components, such as car stereo, air bags, cubbyhole, glove compart-
ment, ashtray, lighter, gear stick or hand brake.
If you would like to use the device during your journey, positioning it in
the front area on the driver’s side is advisable. Sit in the vehicle and
check whether you can reach the device without difficulty.
After having found a suitable position for the BURY CP 1000 CarPhone
in the vehicle you can now mount the BURY CP 1000 CarPhone with the
Vehicle Mount.
The end of the cable with the small Molex connector is ideally suited for
placing through small openings in the dashboard area. This facilitates
a practically invisible installation of the cable. Take the length of the
cable into account and make sure that it is of sufficient length to reach
the intended location of the electronics box.
Important:
When positioning the BURY CP 1000 CarPhone please take X
care that the BURY CP 1000 CarPhone does not impair the
view onto the road, that it will not be installed in the impact
zone of the passenger compartment (amongst others in the
airbag inflation zones) and that the cable may be laid with-
out any problems.
Please avoid direct sunlight on the BURY CP 1000 Car- X
Phone or high internal temperatures, which can be rapidly
reached in parked vehicles.