BURY EasyTouch Pro - Manual (Page 23)

23
In the Brightness menu, the intensity of the light diodes in the display can be changed. Use the
vertical buttons for this.
If you have changed settings and the HFCK is not working as desired then you can return the HFCK
to factory settings with the Factory settings function.
Under Version info, you can see information on the software and hardware installed on the HFCK.
You can find all up-to-date software updates on our website www.bury.com. After downloading the
software, activate the current BURY Device Firmware Update version. Now, select the desired
language and confirm with OK. Select the corresponding device from the list and confirm your
selection with the OK button. When the BURY Easy Touch Pro system is switched off, hold the
power button pressed down for about 10 seconds until “Update…” appears in the display. While
pressing the power button, connect the system with the cable and click on “next”. If the system is
connected successfully and is in Update mode, a window with the software files is shown. Then,
click on browse, search and select the correct file and click on “next”; the update will start.
When the update is completed successfully, a corresponding notification appears in the display;
now, click on “finish” and wait for the system to restart. When the system shuts down and then
restarts, disconnect the cable.
Note:
Do not switch off the power supply to the HFCK during the update. We recommend X
that the HFCK be updated by a BURY dealer.
Please visit www.bury.com to find your nearest dealer. X
After device has been updated please wait until home button stops blinking and X
device automatically starts.