Echo CS-330T Serial C04212001001 - C04212999999 - Manual (Page 20)

20 X7503245101
© 08/2013 ECHO Inc.
OPERATION CS-330T
2. Fill the fuel tank with fuel mixture. Do not over fill.
3. Fill the chain oil tank with lubricant. Do not over fill.
4. Move control lever (choke/ignition switch) (A) forward to
(close choke ) position.
5. Lay unit on a flat, clear area and keep bar and chain clear of
all obstacles. Securely hold and pull starter handle several
times until engine starts, or first starting sound is heard. (7
pulls maximum)
Note: Do not pull starter rope out to the maximum possible
position.
Do not allow recoil handle to snap back against the
casing.
6. Move control lever (choke/ignition switch) to (RUN ( I ))
position. (Do not move to “Stop” position.) If necessary,
restart the engine.
• After choke lever is moved to RUN position, throttle
remains slightly open (fast idle latch condition).
• The chain will attempt to move when engine is started with
fast idle throttle latch engaged.
• Do not start engine before chain brake is locked.
Note: If engine does not start after 5 pulls with choke in (RUN ( I )) position, repeat cold start instructions.
• After starting the engine, immediately squeeze and then release throttle trigger to release fast idle
throttle latch, otherwise severe brake damage may occur.
• Never use fast idle throttle latch for cutting.
• Use the fast idle throttle latch only in starting.
7. Allow unit to warm up at idle for several minutes.
Note: Do not increase engine speed while chain brake is locked. Severe brake damage will result.
A
B
B
A