Echo CS-330T Serial C04212001001 - C04212999999 - Manual (Page 22)

22 X7503245101
© 08/2013 ECHO Inc.
OPERATION CS-330T
Checking Chain Tension
Chain tension should be checked frequently during work and
corrected as necessary.
Do not operate with a loose chain.
Chain Lubrication Test
Hold the chain just above a dry surface and open the throttle to
half speed for 30 seconds.
A thin line of “thrown” oil should be seen on the dry surface.
Cutting Instructions
General
•
This chain saw is designed for cutting wood or wood
products. Do not cut solid metal, sheet metal, plastic or
any non-wood materials.
•
Read the ECHO “CHAIN SAW SAFETY MANUAL”
included with your chain saw for additional cutting and
safety instructions.
• Wear suitable hearing protection such as earmuffs or
earplugs to protect against objectionable or
uncomfortable loud noises.
• Do not let the tip of the bar touch anything while the
engine is running. At cutting speed the chain is moving
at a high rate of speed. Should the tip contact a limb or
log while the chain is moving, the tip will be pushed
upward with considerable force. This is known as
kickback. Avoid it!
In all circumstances the operation of the chain saw is a
one-man job. It is difficult at times to take care for your own
safety, so don’t assume the responsibility for a helper as well.
After you have learned the basic techniques of using the saw,
your best aid will be your own good common sense.
For more information on
scan this QR code.
Kickback