Echo CH500H Owners Manual v.3 - Manual (Page 10)

5" and 8" Skid Steer Chipper
6
ASSEMBLY
2.3.1 MOUNTING THE CHUTE TO FEED ROLLER
HOUSING:
The chipper chute must be mounted to the feed roller
housing. On the CH800H the chute is held in place with
8 bolts, on the CH500H the chute is held in place with 6
bolts. Both models use a chute support.
1. Place the chute on the roller support weldment. Have
someone assist if necessary.
2. Align the chute with the mounting holes.
3. Insert all 6 or 8 (depending on model) 3/8” carriage bolts
into the mounting holes. The CH800H is mounted with
8 bolts. The CH500H is mounted with 6 bolts. It may
be helpful to align the holes with a punch.
4. Place washers and nuts on the opposite side of the
bolts and tighten to proper torque.
2.3 MOUNTING THE CHUTE
2.2 ATTACH DISCHARGE TUBE - CH800H
Keep nuts as tight as possible while allowing the
discharge tube to freely turn.
NOTE
1. Attach one clamping ring(1) and one spacer ring(2) to
discharge tube base(3) using three 3/8 x 1 1/4" bolts(4)
and nylock nuts(5). Tighten leaving 1/16" gap to assist
in mounting to flange. See Figure 2.4.
2. Slide the tube onto the mounting flange on the chipper
frame. The discharge clamp(1) should slide underneath
the lip of the flange. Tighten the bolts to secure it.
3. Install the second half of the spacer(2) and clamp
ring(1) on the discharge tube with 3/8 x 1-1/4" bolts(4)
and nylock nuts(5).
4. Attach lanyard with discharge pin (11) as shown in
Figure 2.5.
1
2
3
4
5
6
7
9
8
10
Figure 2.6, Attach discharge deflector
Figure 2.4, Attach clamp ring and spacer
Figure 2.5, Attach discharge tube
1
2
4
5
11
5. Lubricate the chute by applying grease to the grease
zerk at the base of the chute. Rotate the chute and
apply grease until the chute rotates freely.
6. Rotate the tube 360 degrees and lock it in place with
the lock pin to make sure it is mounted correctly.
7. Attach the discharge deflector(6) to the discharge tube.
Connect the deflector with two 5/16 X 1 1/4" bolts(7)
through the lower hole in the discharge tube. Run these
bolts through the inside of the tube, washer, deflector,
washer, and then knob(8).
8. Finish bolting the deflector to the tube with two 5/16 x
1" bolts(9) through the end hole in the discharge tube
and secure with 5/16 washers & nylock nuts(10).