Bissell BS-9400F - Manual (Page 17)

Prepared by Monique Lania 17 Call Servicing Guide ProHeat 2X 9400F.doc
Consumer reports the water that is sprayed out is not hot.
Solution 1:
Is the machine switched on at the power outlet in the wall?
Allow heater to warm up for about 2 minutes. Is the water
spraying out hot now?
Yes, is the power switch and red heater switch on the unit
switched to ON (l) position?
Yes
** NOTE: The heater will increase the water temperature by
25°f. You should start with hot tap water in the bladder.
Empty the Tank-in-Tank assembly with hot tap water (Not
boiling or water heated in the microwave).
No, refer customer to an Authorized Service Centre Yes, problem solved
No, switch the power on, problem solved
No, switch the power switch and red heater switch to ON (l) position, problem solved