AiM GPS05 Module - Manual (Page 16)

GPS05 Module
User manual
Release 1.01
2 5
4.4 – The GPS Lap timer
This new feature allows the user to get lap and split times without using beacon
transmitters nor optical/magnetic receiver. All is needed is a GPS05 Module
connected to MyChron4/MyChron4 2T with 31.57.06 (or later) firmware version
installed.
3 0
4.4.1 – Preliminary operations
Before starting GPS setting, two preliminary operations are required.
First of all check and set the correct number of lap marker, start/finish line and splits,
in MyChron4 configuration. The maximum number of lap marker allowed is 5 (4
splits + start/finish line). For further information on this subject refer to the logger user
manual.
The second preliminary operation is to set lap type in MyChron4 configuration. Here
below the two available options are shown.
Selecting “GPS Laptimer” it is possible to leave the optical/magnetic receiver
connected and the system will automatically disable it when GPS05 Module with lap
timer function is connected.
If – for any reason – GPS05 Module is disconnected from the logger, the system will
automatically switch to “Type: magnetic/Optical”.
www.aim-sportline.com 15