AiM GPS05 Module - Manual (Page 8)

GPS05 Module
User manual
Release 1.01
2 2
2.4 – Configuration Wizard
No system configuration is needed. The systems self-configures at start up.
It is suggested to switch on the system a few minutes before entering the track.
9
2.5 – GPS Laptimer
GPS05 Module is now available with a new and very useful feature: lap timing.
It allows to show and record lap/split times without installing any beacon receiver nor
transmitters. It is only sufficient a GPS05 Module with firmware version 35.13 or later
connected to an MXL with firmware version 14.86.22 or later.
The first operation to be done is GPS beacons setting for the complete lap and for
the splits. This allows the module to capture lap/split times.
WARNING: this operation is to be performed the first time and once only for
each track. Next time the track is automatically recognized by the logger.
2 8
2.5.1 – Preliminary operation
GPS Lap timer can detect both lap and split times but, being an external expansion
that works as a slave device, its detection mode with or without splits depends on the
configuration of its master logger, in this case MXL. This means splits have to be set
via software in “Lap” box of Race Studio 2 “System configuration” window (accepted
values are between 1 and 6). MXL visualization mode is to be set as well as and then
configuration has to been transmitted to the logger. Here below is shown how to set
these parameters.
Please refer to Race Studio Configuration user manual for further information about
the system configuration.
www.aim-sportline.com 7