AirLive CamPro HD - Manual (Page 108)

3. Playback
AirLive CamPro HD User’s Manual
103
Define motion search area:
Add: Click the “Add” button then drag a rectangle area where you want to
check. The search area will overlay a transparent red mask.
Delete: Define a rectangle area on the image first, then click “Delete” button to
remove the region that was defined.
Default: Click the “Default” button to select full image for motion detection.
Check the “Show Search Image” to display the searching video sequence or
un-check this box to only show the image once the event found.
Check the “Show Detect Mark” to display the detect result on the image by pink
rectangles.
Select the “Sensitivity” to define the sensitivity of detection. The higher value
means the event will be triggered easier.
Select the “Detect Interval” to define the interval of motion detection. If set longer
value, means system will use less CPU computing power to check motion detection.
When the event has been triggered, the window on the right side will display the
triggered image. If the event is not matched your expectation, click the “Continue”
button to search next event.
If you found the matched event, click the “OK” button to return to the playback
panel, and all playing channels will be synchronized to the same timestamp of the
event.
Click Cancel button to abort this motion search job.
z
Sequential Search
Click mouse right button on the channel which
you want to do sequential search, and then select the
“Sequential Search” from the popup menu.