AirLive Ether-GSH8TW v2 - Manual (Page 15)

If VLAN 10 and VLAN ID 20 must be isolated, then user must delete member port 5,6,7,8 in default VLAN
group (VID = 1). See below.
Be aware that CPU port still remains on VID = 1 group now, user can only perform web management through
one of 4 ports, which is port 1,2,3,4 . But if user want to perform web management from other port existing
in different VLAN group, for example port 8 in VID =10, then after creating new VLAN groups, he must
go to System Configuration page, and select Tag VLAN Management Group to 10 by pressing “Apply”
command, then move RJ-45 (web management port) from port 1 to port 8, then user can perform web
management from new RJ-45 port again. But if user forgets what group that CPU belongs to, there are two
ways to solve this condition below.
(1) Through console port, check Configuration of IP if he gets password
(2) Press “ Reset ” button few seconds , let system return to default settings, that is,
---- >> IP address = 192.168.1.100; … VID = 1, all settings return to factory default
After assigning a tag VLAN, there are some attributes parameters that must be assigned for some tag-VLAN
application. Here below are explanation when entering the “Port Config”, they are:
AirLive Ether-GSHTW v2 / 8TW+v2 User’s Manual
12