AirLive Ether-GSH8TW v2 - Manual (Page 31)

2.2.4 IGMP Status
Choose and click IGMP status at command. After execution, diagram will be shown like below, user can
refresh at will. There are IGMP v1, v2, v3 frames that will be shown in the network, our switch only support
IGMP V2, but it will handle some IGMP V3 frames. If this switch is Querier, it will show Querier state and Query
frames it transmitted. If it is not Querier, it only shows how many Querier frames it receives. Only one Querier
in a network section, usually Querier is in router.
AirLive Ether-GSHTW v2 / 8TW+v2 User’s Manual
28