AirLive Ether-GSH8TW v2 - Manual (Page 35)

Chapter 3 Terminal Mode management
Terminal mode is easy to operate, it is useful when in-band Ethernet communication is malfunctioned, or user
is used to CLI interface operation, or he wants to know some parameter setting. For example, before in-band
management through Ethernet, user has to know the IP address, subnet mask …etc, he may get this
information by checking the configuration under IP command, he also may try to modify the IP address, CPU
management group used in tag-VLAN configuration operation, or any other function through terminal mode.
And more conveniently, if user is used to configure the tag-VALN through terminal mode, he won’t be interfered
by the CPU management group issue; CPU is always being connected with him while he is configuring the
VLAN.
User must set up the terminal parameters, such as hyper terminal in Microsoft Window .
Select COM #: COM 1, COM 2 …
Set Baud rate to: 115,200, per second
Set Attribute to 8, None, 1, None (8 bit, No parity, 1 stop bit, No protocol in hardware)
Once terminal is connected, enter the password, the basic operation are shown, and then when press
“?” the commands at top level will be shown as below .
Key in “Command” and then key in “?”
, second level will be shown, for example :
AirLive Ether-GSHTW v2 / 8TW+v2 User’s Manual
32