AirLive G.DUO - Manual (Page 89)

7. Gateway + AP Mode
AirLive G.DUO User’s Manual 82
„ Isolation: Enable Isolation will prevent wireless clients to see each other on the
network.
„ TX Power Level: You can set your TX Output power level here. Please note the
maximum allowable TX output power in EU is 20dBm. Please do not exceed your
country’s legal limit.
7.3.4 Access Control
Operation Mode -> Setup -> Access Control
The G.DUO allows you to define a list of MAC addresses that are allowed or denied to
access the wireless network. This function is available only for Access Point and Gateway
modes.
„ Access Control List
„
Disable: When selected, no MAC address filtering will be performed.
„
Allow list: When selected, data traffic from only the specified devices in the
table will be allowed in the network.
„
Deny list: When selected, data traffic from the devices specified in the table
will be denied/discarded by the network.
7.3.5 Associated Clients
Click on this to show the current wireless clients associated to the AP. It will display MAC
adderss, Trasmit packet, Tx rate, power saving, expire time, and signal strength.