AirLive SNMP-24MGB - Manual (Page 43)

4. Web Management in SNMP-24MGB
AirLive SNMP-24MGB v2 User’s Manual 36
media supports.
Media type NWay Speed Duplex
1000M TP ON/OFF 10/100/1000M Full for all, Half for 10/100
1000M Fiber ON/OFF 1000M Full
In Auto-negotiation mode, no default value. In Forced mode, default value
depends on your setting.
Flow Control:
There are two modes to choose in flow control, including Enable and Disable. If
flow control is set Enable, both parties can send PAUSE frame to the transmitting
device(s) if the receiving port is too busy to handle. When it is set Disable, there
will be no flow control in the port. It drops the packet if too much to handle.
Maximum Frame:
This module offers 1518~9600 (Bytes) packet length to make the long packet.
Excessive Collision Mode:
There are two modes to choose when excessive collision happens in half-duplex
condition as below:
Discard: The “Discard” mode determines whether the MAC drop frames after an
excessive collision has occurred. If set, a frame is dropped after excessive
collisions. This is IEEE 802.3 half-duplex flow control operation.
Restart: The “Restart” mode determines whether the MAC retransmits frames
after an excessive collision has occurred. If set, a frame is not dropped after
excessive collisions, but the backoff sequence is restarted. This is a violation of
IEEE 802.3, but is useful in non-dropping half-duplex flow control operation.
Description:
Description of device ports can not include “ # % & ‘ + \.
4.3.2 Port Status
The function gathers the information of all ports’ current status and reports it by the order of
port number, media, link status, port state, Auto-Negotiation status, speed/duplex, Rx
Pause and Tx Pause. An extra media type information for the module ports 1 and 8 is also
offered.