AirLive WL-1000CAM - Manual (Page 60)

AirLive WL-1000CAM User’s Manual
59
Wireless Setting
Wireless connection Enable or disable the wireless function of the Internet Camera. By
default, the function is disabled.
Network Type Infrastructure – This operation mode requires the presence of a
Wireless LAN Access Point or Router. All communication is done
via the Access Point or Router.
Ad-Hoc
– Select this mode if you want to connect to another
wireless stations in the Wireless LAN network without through an
Access Point or Router.
Available Networks Select the networks listed below and click apply to connect to the
specified network.
SSID The SSID (up to 32 printable ASCII characters) is the unique
name identified in a WLAN. The ID prevents the unintentional
merging of two co-located WLANs.
You may specify a SSID for the card and then only the device
with the same SSID can interconnect to the card. If you want to
add one of the networks nearby to the profile list, pull down the
menu, all the networks nearby will be listed and you can add one
of them to the profile list.
Channel This setting is only available for Ad Hoc mode. Select the number
of the radio channel used for the networking. The channel setting
should be the same with the network you are connecting to.
Basic Rate The camera will force to the data rate that you selected to
transmit data.
Authentication and
Encryption Type
Choose the authentication type you want to use.
―None‖ means that you don’t want any encryption for wireless.
―Open System‖ means that you can use WEP for encryption or
not to encryption. When you select ―Shared Key‖, you must use
WEP for encryption. The last option is ―WPA-PSK‖. When you
select this authentication type, you can encryption your wireless