AirLive WN-250R - Manual (Page 127)

4. Appendix
AirLive WN-250R User’s Manual 118
Reset (10): You can also click ‘Reset’ button to unselect all MAC addresses.
Enable IP Check this box to enable IP address based filtering, and please
Filtering (11): select ‘Deny’ or ‘Allow’ to decide the behavior of IP filtering table.
If you select deny, all IP addresses listed in filtering table will be
denied from connecting to the network; if you select allow, only IP
addresses listed in filtering table will be able to connect to the
network, and rejecting all other network devices.
IP Filtering All existing IP addresses in filtering table will be listed
Table (12): here.
Add PC (13): Click this button to add a new IP address to IP filtering table, up to
20 IP addresses can be added.
Please refer to section 3-3-1-1 ‘Add PC’ below.
Delete (14): If you want to delete a specific IP address entry, check the ‘select’
box of the IP address you want to delete, then click ‘Delete Selected’
button. (You can select more than one IP addresses).
Delete All (15): If you want to delete all IP addresses listed here, Please click
‘Delete All’ button.
After you finish with all settings, please click ‘Apply’ (16) button and the following message
will be displayed on your web browser: