Bissell Proheat2x 9500-p - Manual (Page 14)

w w w. b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
O
perations
14
8. Remove and rinse tools in clean, running
water. dry and replace in the tool caddy.
9. it is recommended that you suction clean
water from a bowl to rinse out the hose.
10. before replacing lift end of hose and
stretch out to ensure all water is cleared
from hose.
11. coil flex hose around the tool caddy.
12. empty 2-in-1 water tank and rinse out,
following the instructions on page 12.
13. Return Readytools dial to floor setting.
Deep reach tool attachment
(Select models only)
Do Not Delay! Attending to an acci-
dent soon after it occurs ensures the
most optimal clean. Leaving it for an
extended period of time may cause
it to set and become permanent.
1. follow the instructions on page 10 for filling
the 2-in-1 water tank and the formula tank.
2. follow instructions 3-6 on page 13 under
"cleaning with attachments".
3. set tool on stain and press the trigger to
spray solution onto the area to be cleaned.
4. slowly move the tool back and forth
over the soiled surface, keeping the tool
in contact with the carpet.
5. Release trigger and move tool slowly
over the soiled area to suction up water
and dirt.
6. continue to clean the area, working in
small sections, until no more dirt can be
removed.
7. Remove tool from hose when finished.
clean under warm water before storing.
Cleaning with attachments continued
10.
3.
5.
7.