Bissell Proheat2x 9500-p - Manual (Page 9)

w w w. b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
9
O
perations
Before you clean
1. Move furniture to another area if
cleaning an entire room (optional).
2. Pick up all loose dirt, debris, and
pet hair before deep cleaning. if
you are cleaning just a small area of
carpeting or less than a whole room,
the ProHeat 2X may be used to vacuum
the area before deep cleaning. be sure
to keep the red filter screen in the 2-in-
1 tank lid free of lint so that suction is
maintained (see step 4 on page 17).
When you are done vacuuming, clear
the red filter screen of any lint and rinse
both the dirty water and the clean solution
tank (inside the flexible bladder) with
warm water before starting the deep
cleaning process.
3. Plan your cleaning route to leave an exit
path. it is best to begin cleaning in the
corner farthest from your exit.
4. Pretreating (optional)
Pretreating is recommended to improve
cleaning effectiveness for heavily soiled
carpet in high traffic areas such as
entryways and hallways.
Option A: BISSELL Tough Stain
PreTreat
A. spray the bissell tough stain
Pre-treat formula onto heavy traffic
areas, soiled areas, or stains.
B. allow to penetrate for at least 3 minutes.
C. clean as normal, using the bissell
ProHeat 2X machine on the high
traffic setting, following the
instructions below.
Option B: CleanShot
follow instructions on page 12.
ATTENTION:
some berber carpets have a
tendency to fuzz with wear.
Repeated strokes in the same
area with an ordinary vacuum
or deep cleaner may aggravate
this condition. Please see stain
Removal instructions on page 15.
B R U S H S U C T IO N
1
STAR
T
HERE
——— 4'——— 2
3
4
8
7
6
5
9
10
11
12
EXIT
——— ——— 3'