Beko DVD 2008 - Manual (Page 26)

Notes on Service
Check the following guide for the possible cause of a problem before contacting service.
Symptom Cause Measure
No power The power plug is disconnected Connect the power plug into the wall outlet securely
No picture
The TV is not set to receive DVD signal output
Select the appropriate video input mode on the TV so the
picture from the DVD player appears on the TV screen.
The video cable is not connected securely Connect the audio cable into the jacks securely.
No sound
The audio cable is not connected securely Connect the audio cable into the jacks securely
The power of the equipment connected with
the audio cable is turned off.
Turn on the equipment connected with the audio
The setting of output sound type is not correct. Set the audio setting correctly
The playback
picture has
occasional
distortion
The disc is dirty Eject the discs and clean it
It is in fast forward or fast reverse playback
Sometimes a small amount of picture distortion may
appear. This is not malfunction.
Brightness is
unstable or noises
are produced on
playback pictures
The copy protection effect.
Connect the DVD player to the TV directly
The DVD player
does not start
playback
No disc is inserted
Insert a disc
An unplayback disc is inserted Insert a disc(Check the disc type and color system.)
The disc is placed upside down. Place the disc on the disc tray correctly inside the guide
The disc is not placed within the guide. Place the disc on the disc tray correctly inside the guide.
The disc is dirty Clean the disc
A menu is on the TV screen. Press the SETUP button to turn off the menu screen
The parental lock function is set.
Cancel the parental lock function or change the parental
lock level.
Buttons do not
work. Power supply fluctuations or other abnormalities
such as static electricity may interrupt correct
operations. Turn the power on or off with the POWER button. Or
disconnect the power plug and insert it into the wall
outlet again.
The remote
control does not
work properly.
The remote control is not pointed at the remote
sensor of the DVD player. Point the remote control at the remote sensor of the DVD
player.
The remote control is too far from the DVD
player.
Operate the remote control within about 7m
The batteries in the remote control are
exhausted.
Replace the batteries with new ones.
24