Allen&Heath DP 1000 USER GUIDE - Manual (Page 24)

M
AINS
P
OWER
I
NPUT
ON/OFF
0 I
FUSE
T500mA
250V 20mm
100 - 240 V.AC
47-63 Hz ~
MAINS INPUT
30W MAX
ON/OFF
I 0 AC ONLY ~ 47- 63 Hz 100-120V T10A
FUSE
1000W MAX
MAINS INPUT
V.AC
220-240V T5A
Mains electricity is dangerous and can kill.
Refer to and heed the warnings printed at the
beginning of this user guide and on the console
rear panel.
DP1000 M
AINS
I
NPUT
Ensure that your local mains supply is the same as
the mains voltage setting marked on the console rear
panel. If it is not then contact your dealer.
DL1000 M
AINS
I
NPUT
Due to the lower mains current requirements of the
DL1000 it has been possible to engineer the mains
input for universal voltage input. Ensure that your
local voltage is within the range printed on the
console rear panel.
Make sure that the mains plugs are
correctly plugged into the distribution outlet and
console IEC input socket before switching the
console on.
Always turn the console on first and any
connected power amplifiers last. If amplifiers are
already turned on make sure that their level
controls are turned down before turning on the
console. This is not necessary with the built in
icon power amplifier as it includes a 2 second
switch on delay to protect the loudspeakers.
M
ONO AND
S
TEREO
C
HANNEL
I
NPUTS
MIX
MIC I
NPUT
The 6 mono and 2 stereo channels each provide a
balanced XLR input for connecting microphone
signals. These are wired pin 2 = hot as shown.
Standard balanced (2 core + shield) mic cables
should be used. The input sensitivity may be
adjusted to accept a wide range of microphone
signals from a low –55dBu typical of distant stage
miking, to a high –8dBu typical of close vocal
miking. +48V can be globally switched mic XLR
sockets 1 to 6 when you use microphones that require
phantom powering. +48V is not fed to channel 7 and
8 mic inputs.
Do not connect unbalanced (single core)
cables or sources to the XLR inputs when
phantom power is applied. No damage will be
done to non powered balanced microphones as
long as balanced cables are used.
Always mute the channel or turn the fader
off when plugging or unplugging the inputs.
4 - 2 icon
SERIES