Allen&Heath DP 1000 USER GUIDE - Manual (Page 3)

IMPORTANT INSTRUCTIONS
READ THE FOLLOWING BEFORE PROCEEDING. Please keep these
instructions for future reference. All warnings printed here and on the
equipment should be adhered to.
WARNING
Do not open the icon. There are no user
serviceable parts inside. Refer servicing or repair
to qualified service personnel only.
Connect the icon to a mains power supply only
of the type and voltage as marked on the rear
panel. Failure to do this is a fire and electrical
shock hazard.
Use the power cord with sealed mains plug
appropriate for your local mains supply as
provided with the
icon. This equipment must be
earthed (grounded). Do not remove the earth
connection from the power cord.
Route the power cord so that it will not be walked
on, have heavy items placed on or against it or be
subject to heat, moisture or tension. If the power
cord is damaged or cut refer to your dealer for a
replacement. A damaged or modified power cord
is a potential fire and electrical shock hazard.
To reduce the risk of fire or electric shock do not
expose the
icon to rain or water or use it in damp
or wet conditions, and do not place containers of
liquids on it which might spill into any openings.
Do not insert or remove an electric plug with wet
hands. Switch off the mains supply before
plugging or unplugging the equipment.
Unplug the equipment during lightning storms or
if it is to remain unused for a long period of time.
Do not locate the icon in a place subject to
excessive heat or direct sunlight as this could be a
fire hazard. The ambient operating temperature
should not be less than 5°C (41°F) or greater than
35°C (95°F).
Do not obstruct the ventilation slots or position
the
icon where the air flow required for
ventilation is impeded. icon uses forced air
cooling with ventilation slots on the front, sides
and underside. Do not operate the
icon on soft
materials such as a thick pile carpet or sofa which
may block the underside openings. If the
icon is
to be operated in a rack unit or flightcase ensure
that it is constructed to allow correct ventilation.
Do not subject the icon to excessive shock or
vibration. Ensure adequate protection when
moving, transporting or shipping the
icon.
CAUTION
Turn off the icon immediately if it is exposed to
moisture, liquid spilled on the panels, objects
fallen into the openings, the power cord become
damaged, if the equipment has been dropped or
become damaged, or if smoke, odour or noise is
noticed. Consult your dealer for repair.
The icon is a heavy piece of equipment due to
the nature of the internal power supply and power
amplifier components. Always ensure you are
correctly positioned and grip securely when
lifting, moving or transporting the equipment.
Before operating the
icon ensure that it is stable
and securely positioned. Failure to ensure this
may result in injury to yourself or damage to the
equipment.
Follow the instructions printed in this guide for
the installation and operation of the
icon.
Avoid electromagnetic, radio frequency and
magnetic fields such as those generated by
televisions, computers, motors and lighting
equipment. If interference is encountered
relocate the affected equipment or cables.
Avoid the use of chemicals, abrasives or solvents
in cleaning the
icon. Use a soft brush and dry
lint-free cloth.
Connect the icon as specified using the correct
cables and connectors for their intended purpose
only. Do not connect any source of AC or DC
power to the
icon audio connectors.
Set the output levels to minimum when
connecting external equipment or reconfiguring
the
icon.
Do not operate the equipment for a long period of
time at a high or uncomfortable volume level as
this may cause permanent hearing loss.
icon
SERIES iii