Anchor PERFECTSHADE - Manual (Page 6)

Step 13
Remove fabric from bag. Do not drag over concrete or
other rough surfaces as this could damage the fabric.
Carry the fabric up the ladder to the ridge.
Throw the fabric over the ridge as shown in Figure 9. Be
certain that the fabric is right side up with the seams run-
ning perpendicular to the ridge. You will know the fabric
is right side up when the fl aps at the corners are on the
top side.
Step 14
At this point you need to decide which corner will be
the corner that will be your wire rope attachment corner.
(Corner AA or DD) This corner will be the one where the
wire rope loops are protruding from the corner of the
fabric. Let the fabric fall loosely down the hips, keeping
it fairly centered on the ridge. (Figure13)
Step 15
Start at the adjacent corner from the wire rope attach-
ment corner that does not have the web handles. Pull
the top down over the corner and insert the Corner Pin
into the hole in the fabric. Tuck the wire rope under the
pin and then pull the corner fl ap down over the pin so
that the corner pocket catches on the pin. (See Figure
10).
Step 16
Proceed to the corner diagonally opposite the fi rst cor-
ner. Using short bursts, pull the fabric down over the
corner using the web handles and attach as in Step 15.
(See Figure 11).
Step 17
Proceed to the corner opposite the wire rope attachment
corner. Using the same technique as on Step 16, attach
this corner.
Step 18
Proceed to the last corner (The wire rope attachment
corner - See Figure 12). Slide a pull rope from the instal-
lation kit (sold separately) through the web handles as
shown in Figure 11. Pull the corner down
until the hole is caught over the corner
pin. (A second person on a ladder may be
required to guide the pull rope so that the
corner is more easily pulled into place.)
Remove the pull rope. Note that the cable
loops will be hanging loose.
Step 19
Attach the eyebolts, neoprene washers and
wing nuts. (See Figure 13) These will be
attached to the two uprights adjacent to
the wire rope attachment corner with the
eyebolts facing the wire rope attachment
corner. Place one neoprene washer each
side of the plate, neoprene side down, be-
tween the eyebolt and wing nut to prevent
scratching of the frame fi nish.
Figure 9
Figure 10
Wire rope
attachment
corner with
ends hanging
loose
Seam running
perpendicular
to ridge.
Ridge
Corner Pin.
Corner Flap
Wire Rope
Figure 12
Wire rope
attachment
corner.
Web
Handles
Figure 11
Wire Rope
Pull Rope
Wire rope
attachment
corner.
6