B&B Electronics 232SPS2 - Manual (Page 4)

232SPS2-3903 Manual Chapter 2: Parallel to Serial Installation 3
B&B Electronics -- PO Box 1040 -- Ottawa, IL 61350
PH (815) 433-5100 -- FAX (815) 433-5104
CHAPTER 2: PARALLEL TO SERIAL
INSTALLATION
When converting data from your parallel port to a serial
communication format, position #8 of the dipswitch must be "ON".
The other seven positions should be set to match the data format of
your serial printer. Refer to Table 5.1 for dipswitch setting
specifications.
232SPS2
232PS
Data Flow
Serial Printer Parallel Port
CONNECTING THE 232SPS2 TO YOUR PARALLEL PORT
The 232SPS2 uses most of the available pins on the parallel
port. To insure proper operation, you should use a cable that
connects all 25 pins from connector to connector. B&B's Model
232AMM5 is recommended. For detailed information on which pins
are connected on the parallel port, refer to Appendix A.
CONNECTING THE 232SPS2 TO YOUR SERIAL PRINTER
The connections required between your 232SPS2 and your
serial printer depend on the type of flow control used. There are two
kinds of flow control, XON/XOFF control and hardware handshaking
control. Dipswitch position #4 must be "OFF" for XON/XOFF control.
Dipswitch position #4 must be "ON" for DTR handshaking. For more
detailed information on serial port connections, refer to Appendix B.
4 Chapter 2: Parallel to Serial Installation 232SPS2-3903 Manual
B&B Electronics -- PO Box 1040 -- Ottawa, IL 61350
PH (815) 433-5100 -- FAX (815) 433-5104