B&B Electronics 232SPS2 - Manual (Page 8)

232SPS2-3903 Manual Appendix A: Parallel Port Connections A-1
B&B Electronics -- PO Box 1040 -- Ottawa, IL 61350
PH (815) 433-5100 -- FAX (815) 433-5104
APPENDIX A: PARALLEL PORT CONNECTIONS
The parallel port connections for the parallel to serial and serial
to parallel mode are shown in Table A-1, and Table A-2,
respectively. The connections required are the same for both modes
of handshaking. The error lines on the parallel port are forced to the
"no error" states. If the printer is off-line, out of paper, etc., the
232SPS2 will force the busy line (Pin #11) on the parallel port high
(logic "1") when in parallel to serial mode. If a error occurs in serial
to parallel mode, the XOFF character will be sent or DTR will be
lowered depending on type of flow control used. (NU - Indicates a
signal is not used or is not “passed through”)
Table A-1
Parallel to Serial Mode
DB-25
Pin #
Signal Name 232SPS2
Direction
1 Strobe Input
2 Data
bit #0 Input
3 Data bit #1 Input
4 Data bit #2 Input
5 Data bit #3 Input
6 Data bit #4 Input
7 Data bit #5 Input
8 Data bit #6 Input
9 Data bit #7 Input
10 Acknowledge Output
11 Busy Output
12 PE "0" Output
13 SLCT “1” Output
14 Auto Feed Input (NU)
15 Error "1" Output
16 INIT Input (NU)
17 SLCT IN Input (NU)
18-25 GND
232SPS2-3903 Manual Appendix A: Parallel Port Connections A-2
B&B Electronics -- PO Box 1040 -- Ottawa, IL 61350
PH (815) 433-5100 -- FAX (815) 433-5104
Table A-2
Serial to Parallel Mode
DB-25
Pin #
Signal Name 232SPS2
Direction
1 Strobe Output
2 Data
bit #0 Output
3 Data bit #1 Output
4 Data bit #2 Output
5 Data bit #3 Output
6 Data bit #4 Output
7 Data bit #5 Output
8 Data bit #6 Output
9 Data bit #7 Output
10 Acknowledge Input
11 Busy Input
12 PE Input (NU)
13 SLCT Input (NU)
14 Auto Feed “1” Output
15 Error Input (NU)
16 INIT “1” Output
17 SLCT IN “1” Output
18-25 GND