B&B Electronics 232SPS2 - Manual (Page 5)

232SPS2-3903 Manual Chapter 3: Serial to Parallel Installation 5
B&B Electronics -- PO Box 1040 -- Ottawa, IL 61350
PH (815) 433-5100 -- FAX (815) 433-5104
CHAPTER 3: SERIAL TO PARALLEL
INSTALLATION
When converting data from your serial port to a parallel
communication format, position #8 of the dipswitch must be "OFF".
The other seven positions should be set to match the data format of
your computer's serial port. Refer to Table 5.1 for dipswitch setting
specifications.
CONNECTING THE 232SPS2 TO YOUR PARALLEL PRINTER
The 232SPS2 has a DB-25 female connector on its parallel port.
Most parallel printers use a Centronics 36-pin connector. To insure
proper operation, you should use a cable that connects all 25 pins
from the DB-25 connector to the appropriate pins on a Centronics
36-pin connector. B&B's Model CPC is recommended. For detailed
information on which pins are connected on the parallel port, refer to
Appendix A.
CONNECTING THE 232SPS2 TO YOUR SERIAL PORT
The connections required between your 232SPS2 and your
serial port depend on the type of flow control used. The type of flow
control used depends on the software you are using. If you are
unsure which type of flow control your software uses or if you plan to
run different kinds of software, you should use a cable that connects
all 9 pins from connector to connector and set the handshaking
mode to be XON/XOFF control. In this mode both DTR handshaking
and XON/XOFF control are used for flow control. Dipswitch position
#4 should be "OFF" for XON/XOFF control. For more detailed
information on serial port connections, refer to Appendix B.
6 Chapter 3: Serial to Parallel Installation 232SPS2-3903 Manual
B&B Electronics -- PO Box 1040 -- Ottawa, IL 61350
PH (815) 433-5100 -- FAX (815) 433-5104