Appendix configuration using telnet interface – Atop Technology MB5416A2 User manual User Manual
Page 64
Atop Modbus Gateway
MB54XX-X Series
User’s Manual V 1.1
61
Appendix Configuration using Telnet Interface
The MB54XX Modbus Gateway device also has a built-in Telnet server program such that
users can also configure the device using Telnet console software. To start the device
configuration using Telnet console, please go to Windows Command software (Start→Run)
and use “telnet” command to access the device. In the “Run” window, enter “telnet
device_IP_address
” (For example, telnet 10.0.50.100 if the device is connected to LAN1 port)
as shown in Fig. The system will prompt for Username and Password. After the valid
username and password are entered, the main menu shall appear as in Apx. 10. It shows all
the configurations that can be used on the device.
If Telnet is not yet configured, please follow the steps mentioned below to configure it.
Note:
The steps described below are for Windows® platforms.
You can always press “ESC” key to return to the upper layer menu.
If the device does not receive any command within 3 minutes, Telnet connection will be automatically
terminated.