5 tcp settings, Tcp settings – Atop Technology MB5416A2 User manual User Manual
Page 33
Atop Modbus Gateway
MB54XX-X Series
User’s Manual V 1.1
30
3.5.5 TCP Settings
Settings for representing a Modbus TCP connection using the internet are set here. First go
to
Basic Settings ↔ TCP Settings, then proceed to choose whether to enable TCP ticking on
the
“Enable” box.
Fig. 3. 14
TCP Slave: When on this mode, the device will run on Slave mode and wait to receive
Modbus requests from the Master; data transmission is done under a Modbus TCP
format.
Remote IP Address shows the device
’s slave node IP address.
TCP Port shows the device
’s slave node TCP port.
VCOM inactivity’s Time Out can be set as well (which is the period of time allowed
between actions), with a maximum of 600 minutes or 10 hours. If no action has been
taken after this period, Modbus TCP connection will be automatically terminated by the
system.