Auto Meter 6013 - Manual (Page 16)

Chapter 3. Operating the Display System
10 Race Dash Users Guide
Resetting the Peak Values
You can reset all of the peak values, except the fastest lap time,
manually. All peak values are reset at the same time. If the
engine is running at or above its gate value when the peak
values are reset, they are set to the current value of each
performance parameter.
To reset the peak values:
• Press and hold Switch 1 to display the peak values.
• While holding Switch 1, press and hold Switch 3.
• With Switch 3 held down, you will see the display revert to
the current values. The new peak values that are stored are
those being displayed when you release Switch 3.
If the engine is running below its gate value, the peak values are
not reset to the current values but are set to the values in the
following table:
Parameter New Peak Value
Engine RPM 0 RPM
Wheel speed 0 MPH
Oil Pressure 999.9 PSI
Fuel Pressure 99.99 PSI
Oil Temperature 0ºF
Water Temperature 0ºF
Battery Voltage 26.0V
Peak Value Memory
The peak values are stored in a memory that is powered by an
internal back-up battery. They remain stored in this memory
when the external power source is disconnected from the system.
The system needs to be returned to Auto Meter every 4-5 years
for the internal battery to be changed. An alarm is triggered when
the power from this battery drops below a safe level and the
warning “MEM BATT” is displayed.