Auto Meter 6013 - Manual (Page 26)

Chapter 4. Configuring the Display System
20 Race Dash Users Guide
Nudge Amount:
Set the number of seconds, in increments of 10 seconds, by
which you want to skip through the data when either of the
Nudge Keys are pressed (see Replaying the Recorded Data
below). We suggest that you use a small value for tracks which
contain short laps and a larger value for longer circuits.
Switching Alarms on or off
You can enable (switch on) or disable (switch off) each of the
alarm warnings by pressing and holding Switch 1 and then
pressing Switch 2.
Note that you might change the preset value of the parameter
slightly while pressing both switches. This does not matter if you
are switching the alarm warning off and, if necessary, you can
correct the preset value after you switch it on again.
Leaving Configuration mode
When you wish to return to the normal display, press Switch 4.