Introduction and warranty, Introduction, Identification – Autoquip SERIES 35 SCISSORS LIFT User Manual
Page 4: Inspection, Planned maintenance program, Responsibility of owners/users, Deflection, 1 introduction, 2 responsibility of owners/users
4
1. INTRODUCTION AND WARRANTY
1.1 Introduction
Please read and understand this manual prior to installation or operation of this lift. Failure to do so could
lead to property damage and/or serious personal injury. If you have any questions, call a local dealer or
Autoquip Corporation at 1-888-811-9876 or 405-282-5200.
Please record the following information and refer to it when calling your dealer or Autoquip.
Model Number:________________Serial Number: ___________________
Installation Date _____/_____/_____
1.1.1 Identification
When ordering parts or requesting information or service on this lift, PLEASE REFER TO THE MODEL
AND SERIAL NUMBER. This information is on a nameplate attached to the leg assembly. Replacement
parts are available from a local Autoquip distributor.
1.1.2 Inspection
Upon receipt of lift, perform a visual inspection to determine whether the lift has been damaged in transit.
Any damage found must be noted on delivery receipt. In addition to this preliminary inspection, carefully
inspect lift for concealed damage. Any concealed damage found that was not noted on delivery receipt
must be reported in writing to the delivering carrier within 48 hours.
Use the following checklist for inspection of lift:
1. Examine entire unit for any signs of mishandling. Carefully check power unit and controls.
2. Thoroughly examine all connections, making sure they have not vibrated loose during transit, and
inspect wiring for any signs of damage.
3. After installation, raise lift and inspect base frame, platform, scissors assembly, and cylinder plumbing
connections.
1.1.3 Planned Maintenance Program
A local Autoquip representative provides a Planned Maintenance Program (PMP) for this equipment
using factory-trained personnel. Call a local representative or Autoquip Corporation at 1-888-811-9876 or
405-282-5200 for more information.
1.2 Responsibility Of Owners/Users
1.2.1 Deflection
It is the responsibility of user/purchaser to advise manufacturer where deflection may be critical to the
application.