Bakers Pride EP-2-2828 User Manual
Page 5
Upper Support Bracket (2)
Rack Guide (2)
Bottom Shelf
5
The fit of the insert to the leg is intended to be snug, you should expect to tap them lightly in place
with a mallet or rubber hammer. Using your fingers screw the ends of the bullet feet into the leg
clockwise until they are at their shortest length.
OR
Casters mount to the bottom of the caster plate with four each: 3/8-16 bolts inserted into a split ring
lock washer and flat washer.
2.
Turn the oven over onto its left side so you can easily reach the bolt mounting locations in the base.
3.
The three holes in the top of each leg will match the bolt locations at each corner of the oven base.
4.
You will need three 3/8-16 hex head bolts and three 3/8 flat washers to mount each leg. Align the
leg to one of the matching bolt holes on the base and insert a bolt and washer. Install the other bolts
and finger tighten into place before using a wrench to fully tighten them all.
5.
Be sure to tighten all bolts for each leg. When installing casters, make sure the two casters with
brakes are installed at the front of the oven.
6.
Carefully stand up the oven. Insure the two legs/casters that touch the floor first when you raise the
oven are blocked and chocked so they do not slip away.
Optional Open Base Feature:
1.
Install bottom shelf and rack guide brackets when installing legs - while oven is on its side.
Refer to leg instructions in Installation/
Manual.
2.
Attach two rack support brackets to base of oven with three screws each bracket.
3.
Install two legs to lower (left) side of oven.Align and attach bottom shelf to these legs with a bolt and
locking nut - One each in the front and back.
4.
Attach last two legs.
5.
Attach bottom shelf to remaining two legs with two bolts and locking nuts - One each in the front and
back.
6.
When the oven is stood up, before moving it to its final location, install four remaining bolts and
locking nuts to the legs - Two on left side, two on right side. Tighten all.
7.
Install two rack guides. Align the bottom pegs to holes in the bottom shelf. Align top hooks to cut-
outs in upper support bracket. Lower into position.
8.
Align oven racks (order separately) to the shelf heights desired and slide into place.
Operation