Bakers Pride EP-2-2828 - Manual (Page 6)

3. ELECTRICAL CONNECTIONS
1 Installation must be performed by a licensed electrician.
2 A separate electrical connection to the mains must be provided for each oven.
3 An all pole disconnect must be provided by the installer.
4 Connection to the electrical service must be grounded in accordance with local codes. In the
absence of local codes refer to the National Electric Code, ANSI/NFPA 70 or the Canadian Electric
Code, CSAC22.2 as applicable.
5 Only bare copper conductors with a minimum insulation temperature rating of 90ºC to be used.
6 The installer must supply a properly sized strain relief bushing for the mains connection that meets
all codes.
7 The oven shall be installed using flexible conduit.
8 The restraint cord must be securely attached to the rear of the oven and to the building structure to
prevent transmitting unnecessary stress to the flexible conduit.
A wiring diagram is affixed to the inner side cover of the oven and included in the rear of this booklet.
The input connection is accessed be removing the right side cover. Field connections are located at the
lower rear corner of the control compartment.
! ! WARNING: Risk of electrical shock. Appliance must be secured to building structure.
Double Stacked
Ovens
Your EP-2-2828 may be
stacked two ovens on top of
one another. In order to
insure the ovens to not slide
or separate, there is a
stacking bracket kit required
for installation at the rear of
the ovens. Two brackets
are installed, one at each
end of the oven securing the
upper oven to the bottom
oven. Refer to the adjacent
illustration.
STACKING
#10 SHEET METAL
SCREW (8)
C5057X BRACKET (2)
6
! !
Caution: Disconnect all ovens from electrical supply before servicing.