Double ovens with front mounted controls, Option “b” access to booster burner – Bakers Pride FC-816 Manual User Manual
Page 26
26
DOUBLE OVENS WITH FRONT MOUNTED CONTROLS
WHEN BUILDING YOUR FACADE, PROVISIONS MUST BE MADE FOR ACCESSING THE FOLLOWING:
(SEE SKETCH 16, PAGE 25)
FRONT:
LEFT SIDE:
REAR:
1.
Hinged control access panels (one per oven)
2.
Push-pull rods (two per oven)
3.
Arched opening and lintel plate IL Forno only
4.
Bake chamber door on lower oven
5.
Combustion chamber doors both ovens
1.
Side service access panels (optional & recommended). Access to this panel eases potential service
access to the valve, booster burner control, booster burner ignition module and thermostat, however
all components may be accessed though the front hinged control access panels (difficult).
1.
2.
Electrical connection- IL Forno only
3.
Gas connections - Each oven has a separate gas connection
4.
Minimum clearance for Service Technician and/or for safe operation
Rear booster burner, flame sensor and igniter - Provision should be considered for potential service
of these components. Following are 3 options:
A.
Rear access panel (recommended).
B.
Hinged or removable panel on the front of the facade to allow the removal of flue cover and
inserts. This provides greater access for a technician to service these components through
the front of the oven (see drawing below).
C.
Through the arched bake chamber entrance (difficult).
SEE INSTRUCTIONS ON PAGES 14-19.
VENTILATION, AIR SUPPLY AND FIRE PROTECTION:
BAKERS PRID
E
OPTION “B”
ACCESS TO BOOSTER BURNER
Flue Cover
Insert
Insert
Lintel Plate