Bakers Pride 616 Manual - Manual (Page 11)

11
On models that include them install the hearth trim strip between the front of the baking hearth stones
and the door frame.
After curing and use, new stones may require re-leveling. This is the responsibility of the owner and
not the manufacturer.
INSTALLATION
BUTT TIGHT
IN-BETWEEN
SEAMS
WEDGE
CEILING TILES
Some models have the option of having a hearth lined ceiling. These tiles will be packed separately
from the oven, may be in the same container as the baking deck tiles.
For Il Forno models there are multiple square tiles that get installed into the top supports by tipping at
an angle, inserting the edge above the support rail toward the center, setting one edge along the support
rail along the side of the cavity and letting the tipped up edge come down to rest on the center support
rail. Center tiles are installed the same way.
For deck ovens a long narrow ceiling stone will be inserted at a cut-out in the front edge along the door
opening. Set the rear end up over the ledge along the back of the cavity. Swing the front edge up
through the cut-out and slide it to the left or right for positioning.