Troubleshooting – Bakers Pride 616 Manual User Manual
Page 20
20
TROUBLESHOOTING
PROBLEM
POSSIBLE
REMEDY
No Pilot
No Gas
Gas supply shut-off.
Shut-off valve in “OFF” position.
Kink in supply tube from valve. Inspect entire length
Blocked supply line
Faulty
valve
Dirty Orifice
Make sure pilot orifice is clean and not blocked. Care must be taken
to clean but not enlarge orifice hole.
Pilot won’t stay lit
Not Enough Gas
Gas flow too low. Check gas pressure
Incorrect orifice. LP orifice in place of Natural.
Blocked Orifice in pilot. Check and clean as required.
Flame too small
Adjust pilot flame
Dirty Contact
Jumper wire at thermostat posts on combination valve must be clean
and tight.
Thermopile must be clean and fastening nut tight to pilot bracket.
Faulty Component
Faulty thermopile or thermocouple. See Thermopile Test Procedure.
Faulty valve. Test for functioning Thermocouple or Thermopile.
Change Valve
Main Burner won’t light
No Gas
No pilot
Valve
Shut-off
Blocked supply line
Faulty Valve. Test gas flow before changing.
Faulty Thermostat. Test gas flow before changing.
Not enough gas
Not enough supply. Test gas flow.
Yellow or lazy flame
Not enough air
Adjust air mixture at inspirator
Not enough gas
Test gas pressure/flow
Flame lifting
Too much air
Adjust air mixture at inspirator
Flame flashes back
High gas pressure
Test gas pressure/flow
Flame POPS when turned
off
Wrong orifice
Verify and change as needed
Flame too large
Over gassed
Test gas pressure/flow
Wrong orifice
Verify and change as needed
Delayed ignition
Plugged burner
Clean
Ventilation
Consult HVAC professional to verify air mixture
Oven takes too long to heat
Not enough gas
Test gas supply.
All technical problems should only be investigated by qualified gas fitters or service technicians. Im-
proper adjustment, alteration or service can cause property damage, injury or death. For problems with
your gas supply or oven operation contact your gas supplier or contact a Bakers Pride Authorized Ser-
vice Agency.