BAND-IT IT2000-AB 1/4 Junior Tool - Manual (Page 3)

Document # I17792 Rev G
© Copyright
BAND-IT-IDEX, Inc. 2009
All rights reserved
www.BAND-IT-IDEX.com
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street Denver, CO 80216-0307 USA
P: 1-800-525-0758 F: 1-800-624-3925
3 of 38
IT2000-AB
1/4” Junior
® Tool
Safety Guidelines
• Read this manual and become familiar with the tool before installing any
clamps.
• Protective eyewear should be worn when connecting and disconnecting
the tool to compressed air sources and during operation.
• Wear appropriate gloves for handling steel while operating this tool,
applying stainless steel clamps and removing scrap clamp tail.
• Clamp tensioning can be immediately stopped by releasing the tool
trigger system.
• When applying clamps, care should be taken to insure fingers and loose
clothing are not in the way of the clamp being applied.
• Never attempt to clamp objects which have a potential to burst, shatter
or otherwise cause bodily harm.
• Disconnect air supply and electrical power prior to maintenance and
disassembly of tool components.
• Liquids or lubricants should never be put into the air lines.
Warranty:
For Warranty information visit the following URL
www.BAND-IT-IDEX.com/Warranty.html
Warranty &
Safety Guidelines