Barranca Diamond HP30 Slab Saw User Manual
Page 18
18
MAINTENANCE FOLLOWING USE
The following maintenance should be performed following each use.
Blade-Shaft Bearings
Remove sheet metal cover over blade shaft and
grease zerk fittings on base mount bearings. Use
premium wheel bearing grease to lubricate all blade-
shaft bearings.
Shaft bearings
Cross-adjustment rail system
Cross-Adjustment Rail System
The slab saw cutting oil splash will adequately lubricate
the vice screw-feed, rails and clutch parts. If the
carriage becomes hard to slide over the rails, clean
the rails with WD40 spray and a rag and apply a liberal
amount of Lucas oil stabilizer or grease to the surface of
the steel rails to facilitate travel of the carriage over the
rails. Depending on rock type slabbed, this procedure
may have to be repeated more frequently.
HP30
MAINTENANCE & TROUBLESHOOTING
WARNING
Place the ON/OFF switch in the OFF position and unplug cord prior to servicing and when
changing accessories, such as blades, belts, and the like.