BASELINE Tire Changer - Manual (Page 14)

10 • Important: Always read and follow operating instructions.
Bead Seating
DANGER
NEVER exceed 40 PSI to seat beads while
using this tire changer. If more than 40 PSI
is permitted by tire manufacturer, ALWAYS
use safety cage and clip-on chuck. NEVER
exceed recommended pressure after seating
beads. ALWAYS keep hands and entire body
back from inflating tire.
An exploding tire, wheel, or bead sealing
equipment may propel upward and outward
with sufficient force to cause serious injury
or death to operator or bystander.
WARNING
Check tire pressure frequently. If operator is
unable to obtain Bead Seat, something is
wrong. Deflate tire completely, inspect tire
and wheel, correct any problems found, relu-
bricate both tire beads, and reattempt Bead
Seal and Seat procedures. Follow all safety
instructions in this manual and on machine.
1. Once tire pressure is indicated on the air gauge
(inflation pedal in position 1; foot removed from pedal),
continue to inject air into the tire (inflation pedal posi-
tion 2) in short intervals. Check the pressure frequently.
Stand back during bead seat. Keep hands, arms, and
entire body away from tire during this procedure (figure
20).
Tire beads should move outward and “pop” into their
bead seat position as pressure inside the tire increases.
If this does not happen, a problem exists. Investigate
carefully.
Figure 20 - Stand Back during Bead Seat