BASELINE Tire Changer - Manual (Page 5)

Important: Always read and follow operating instructions. • 1
Principal Operating Parts
Do It Now!
Now is a good time to fill out the Owner’s
Registry Card.
Know Your Unit
Compare this illustration with the unit before placing it
into service. Maximum performance and safety will be
obtained only when all persons using the unit are fully
trained in its parts and operation. Each user should learn
the function and location, of all controls.
Prevent accidents and injuries by ensuring the unit is
properly installed, operated and maintained.
✔
1 Pressure Safety Valve — The high pressure safety
valve is set to exhaust at line pressures above 185 PSI.
2 Air Inflation Gauge — Registers tire pressure when
clip-on chuck is attached to tire valve stem and inflation
pedal is released.
3 Tower — Support for horizontal and vertical slides,
also air storage tank.
4 Important Safety Decal — Important safety informa-
tion for the operator. DO NOT obstruct with tire stickers
or other materials.
5 Inflation Pedal — Three-position pedal that allows
inflation of tires through air hose and clip-on chuck.
6 Bead Loosener Handle — Controls operation of bead
loosener shoe.
7 Clamps — Holds wheel to table top for tire changing.
Position outward to allow outside clamping of wheels.
8 Table Top — Rotating chuck for tire changing.
9 DuckHead® (Mount/Demount Head) — Mounts
and demounts tire from wheel.
10 Swing Arm Adjustment Knob — Adjusts swing
arm/vertical slide assembly for proper horizontal posi-
tioning of mount/demount head.
11 Bead Sealing Nozzles — Expands tire sidewall
to bead seat area of rim to seal tire to rim and allow
inflation.
12 Lube Bottle — Dispenser for rubber lubricant.
13 Clamp Control Pedal — Three-position pedal that
opens, holds or closes rim clamps.
14 Bead Loosener Control Pedal — Controls operation
of bead loosener shoe.
15 Table Top Pedal — Three-position pedal that controls
rotation of table top (forward, off, reverse).
16 Bead Lifting Tool — Used to lift and position tire
bead correctly on duckhead (mount/demount tool).
17 Tire Bumper Guards — Provides protective surface
when bead loosening tires.
18 Bead Loosener Shoe — Pivoting shoe for loosening
tire beads.
19 Vertical Slide Locking Handle — Locks and unlocks
vertical slide and sets correct vertical position to main-
tain head/wheel clearance.
20 Robo-Assist™ — Provides extra leverage when
mounting/demounting tires.
21 Robo-Assist Control Valve — Controls vertical
movement of robotic arm cylinder.
1
2
3
4
5
6
7
8
9
10
11
12
13 14 15 16 17
18
19
20
(If equipped)
21