Bear Archery Compound Bow 2014 - Manual (Page 25)

22
CAM ADJUSTMENTS
- Adjusting Draw Length -
Dual Cam Systems
The Outbreak and G3 Growth cam equipped bows can
be configured to provide a draw length from16’’-30’’ for
the Outbreak, and 15”-27” in 1” intervals. No bow press
is required to adjust the multidraw cam system. To adjust
the draw length, first remove the socket head cap screw
located in the rotating module. Next rotate the module
to the desired draw length and reinstall the screw in the
corresponding hole. It may be necessary to pull the cable
away from the module to provide clearance for the module
to rotate, see the picture below. Next perform the same
operation on the opposite cam. Be sure that both the top
and bottom cams are set to the same draw length position.
The adjustable cam operates on a sliding poundage scale
where an increase in draw length also provides an increase
in peak draw weight. This allows the bow to grow with
the archer. The chart on the previous page shows the peak
draw weight at each draw length for the Apprentice and
Outbreak bows.