Bear Archery Compound Bow 2014 - Manual (Page 35)

32
INITIAL BOW SETUP
Nocking Point and Nock Adjustment
Now that the initial center shot setting is complete, you
need to verify your arrow nocking point. Install the nocking
point or string loop on the bowstring so that when an
arrow is nocked it creates a 90 degree angle to the string.
Another option is to use a process similar to the one used to
determine center shot. With an arrow in the rest and nocked
on the string, firmly hold another arrow against the shelf of
the riser as illustrated. Look down the arrows and verify that
the arrows are parallel. In other words, the spacing between
the two arrows should be the same along the entire length
of the arrows. If not, adjust your nocking point up or down
to correct.
At this time, adjust arrow fletch position to correspond with
the arrow rest you are using. Such adjustments are done
by simply rotating or replacing the arrow’s nock. Carefully
position the nock to provide proper fletch clearance through
the arrow rest. Your local Bear Archery dealer can show you
how to do this or can provide the service for you. Please refer
to the images on the next page for further reference.
Install All Accessories
After your arrow rest and nocking point are installed
correctly you will need to install all other accessories such as
sights, quivers, silencers, peep sights, stabilizers, etc. Before
mounting ANY accessories to the limbs, Refer to page 3 for
important limb information.