Bedrug BED LINERS: BedTred Pro Series - Manual (Page 2)

2. Vehicle Preparation
a. Wash and Dry the bed and tailgate area
thoroughly before proceeding.
b. Remove bolt-in type cargo hooks or load
extenders (if equipped) Cargo hooks will
be reinstalled in Step 10.
IMPORTANT: Truck bed should be at least 68°F
(20°C) for maximum adhesion. Clean all areas
with 70% (or higher) Isopropyl Alcohol before
applying tape. Do not remove backing from any
tape until ready to adhere to the truck bed. When
removing backing, do not touch adhesive. Extra
adhesive strips have been provided in the kit for
future use or if the installer deems more fasteners
are necessary for better fit and appearance.
a. Apply 63.5" piece and one 60" piece of
Hook Fastener to back (loop side) of
Bulkhead Panel as shown leaving the
adhesive side out and backing in place.
b. Apply five pieces of 2" Hook Fastener to
the loop side at the bottom of Bulkhead
Panel.
c. Cut pieces of the 2" wide Hook Fastener
without adhesive tape and attach to
Bulkhead Panel.
Leave 1" of 2" wide Hook Fastener exposed
for future attachment to front edges of side
panels in Step 11.
3. Attach Hook Fasteners To BedTred
Bulkhead Panel.
Procedure
BedTred Truck Bed Liner Installation
Space five pieces evenly along bottom edge.
1"x 63.5" top edge of Bulkhead
1"x 60" below recess
0.25"
from edge Fabric side of panel
1"
4. Attach Hook Fasteners to BedTred
Sidewall Panels.
a. Apply three 10 " long Hook Fasteners above
wheel well and upper tier loading areas as
shown. Do Not Locate in wheel well itself.
b. Apply 6 " pieces at 45° angles outside of
each end of wheel well.
c. Apply 2 " pieces on top and rear edges as
needed.
1"x 2"
1"x 6"
1"x 10"
1"x 2"
BTPROINST Rev. 1 12/13/2010 Page 2 of 6