Bedrug BED LINERS: BedTred Pro Series - Manual (Page 3)

Procedure
BedTred Truck Bed Liner Installation
5. Attach fasteners to BedTred Floor Panel.
a. Cut 1 piece of 1"x 60" in half to achieve two
1"x 30" pieces.
b. Apply two 30" pieces to the center areas
of the Floor Panel no closer than 10" from
the front.
These pieces must be installed in a valley
on the BedTred floor, which will be on top
of a rib in the floor of the truck.
c. Apply one piece of the 1"x 60" to the full
width of the rear edge of floor.
1"x
30"
10"
1"x 60"
6. Zip the BedTred truck bed panels together
From the loop side of the panels, zip the
two side panels to the Floor Panel (starting
at the back of the BedTred) and then zip the
Bulkhead Panel to the Floor Panel.
7. Place the joined BedTred panels in truck
Turn the BedTred over again and place it
carefully into the truck bed.
Position the Floor Panel carefully.
8. Adhere the Floor Panel to the truck floor.
Lay the Bulkhead Panel down onto floor,
then carefully roll the BedTred over on one
side.
Thoroughly clean the area of the floor with
alcohol where the adhesive will be applied.
Be careful not to crease any of the panels as
you fit the BedTred into your truck bed.
Remove the tape backing from that adhesive-
backed hook and roll the BedTred back into
position on that side.
Be careful not to shift position of the Floor
Panel during this step.
Repeat for the other side.
Press fasteners firmly in place.
BTPROINST Rev. 1 12/13/2010 Page 3 of 6