Bedrug BED LINERS: BedTred Pro Series - Manual (Page 4)

10. Some Truck beds are equipped with tie-
down hooks- load extenders and other
equipment on the floor, bulkhead or
sidewalls. For these you must either:
a. Cut a small slit in the appropriate area,
allowing the equipment to protrude through
the BedTred surface (this will not damage
the BedTred) or,
b. If you removed the above equipment as
noted in Step 2, install the BedTred and then
reinstall the equipment over the BedTred
surface.
11. Attach sidewall panels to truck bed.
Begin by attaching the front edge of the side
panel to the Bulkhead Panel. Be sure the 2"
wide hook is secure against the fabric side of
the side panel.
It is best to center and attach the wheel well
area next. Clean attachment areas of bed with
alcohol and let dry. Remove backing tapes
and adhere to truck.
Work from the bottom up then toward the front
and rear.
Repeat with the opposite sides.
Press all fasteners firmly in place.
Procedure
BedTred Truck Bed Liner Installation
Note: An awl works well to locate and
punch holes.
9. Attach Bulkhead Panel to Truck Bed.
Wipe all contact areas with alcohol, then let
dry.
Remove backing tape and attach lower
fasteners first. Work from the bottom up and
the center out.
IMPORTANT: Do not remove backing tape
until ready to adhere tape to truck bed.
Press all fasteners firmly in place.
BTPROINST Rev. 1 12/13/2010 Page 4 of 6