Bedrug JEEP KITS: BedRug for Jeep CJ7/YJ - Manual (Page 2)

Congratulations on choosing the finest interior flooring kit available for your Jeep.
The BedRug material is mold and mildew resistant, easily cleaned with water &
household cleaning chemicals and extremely resistant to most chemicals.
• Kit Contents: Driver side front floor, passenger side
front floor, rear passenger floor, trans hump piece,
side panel right and left, A-pillar right and left, heat
shield material, hardware kit, and instruction sheet.
• Tools needed: Phillips screwdriver, utility knife,
soap, water, and rubbing alcohol.
PreParation
1. Read all instructions before beginning installation.
2. Remove console and old Jeep flooring material
(if equipped).
3. Wash and dry the floor pan areas thoroughly.
4. Cut the hook with tape backing, provided in the hardware kit, to the lengths indicated on drawing (page 5).
Place the loop onto each location. Do not remove the tape backing at this time.
(NoTe: Cut the longest pieces first.)
5. Pre-install provided heat shields on underside of the three front pieces in areas shown below,
using the locator marks. (Fig. 1 thru 3) NoTe: See drawing (Page 5) for trans hump shield placement.
IMPoRTANT: Jeep floor should be at least 68°F (20°C) for maximum adhesion. Clean all areas with rubbing
alcohol before applying tape. When removing backing, do not touch adhesive. If both front and rear kits were
purchased be sure to install the rear cargo area first. If the Jeep has any aftermarket accessories or custom
parts such as seats brackets or roll bars you may need to trim our product to fit.
BRCYJ76F
BEDRUG, INC.
n
635 Old Hickory Blvd, Old Hickory, TN 37138-3162
n
800-462-8435
n
bedrug.com
FIguRe 1: FIguRe 2: FIguRe 3:
Jeep Wrangler CJ-7/YJ BedRug
Interior Installation Instructions
CJ-7
YJ
FRONT KITS: