BKI ALF-FC Automatic Lift Fryer - Manual (Page 30)

Automatic Lift Fryer
28
Troubleshooting
Refer to the table below for troubleshooting information.
Problem Cause Possible Solution
Shortening Heating Too
Slowly Low voltage or improper
voltage Contact an authorized BKI service
agent for corrective action.
Bad thermostat or loose
wires Contact an authorized BKI service
agent for corrective action.
Weak heating elements or
heating elements breaking
down Contact an authorized BKI service
agent for corrective action.
Coil on contactor is bad Contact an authorized BKI service
agent for corrective action.
Breading build-up on heating
elements
Clean heating elements. If problems
persist, contact an authorized BKI
service agent for corrective action.
Filter System Not Working Uncertain Press the reset button on end of pump
and hi-limit reset button under control
panel. If problems persist, contact an
authorized BKI service agent for
corrective action.
Connections not tight Tighten the connections. If problems
persist, contact an authorized BKI
service agent for corrective action.
Filter valve not open Contact an authorized BKI service
agent for corrective action.
Filter paper on screen
clogged with crumbs Change filter paper. If problems
persist, contact an authorized BKI
service agent for corrective action.
Motor hums, but does not
pump Check for clogged pump. If problems
persist, contact an authorized BKI
service agent for corrective action.
Motor and pump coupling
worn Contact an authorized BKI service
agent for corrective action.
No power to control panel Make sure drain valve is completely
closed. If problems persist, contact an
authorized BKI service agent for
corrective action.
Computer Hangs Computer malfunction. Press and hold the Toggle/Clear
button while moving the
FRY/OFF/FILTER switch from FRY to
OFF and back to FRY. If problems
persist, contact an authorized BKI
service agent for corrective action.